News·Information

The UN6 water-cooled pneumatic butt welding machine is a multi-purpose resistance butt welding machine. Xinxing Welding is independently developed on the basis of the fifth generation semi-automatic butt welding machine. It adds a pneumatic system, a water system and a more intelligent control system. It is also known as a copper and aluminum pipe butt welding machine, a pneumatic metal bar butt welding machine, and a flange butt welding machine.

Why the UN6 water-cooled pneumatic butt welding machine can accurately butt so many types of workpieces, such as copper and aluminum pipes, flat irons, stainless steel bars, metal bars, multi-stranded copper wires and aluminum wires, tool steel, etc., half of the effect is because of the intelligent and powerful control system. It has many functions and is much larger than a mini controller.

The reason why the UN6 water-cooled pneumatic butt welding machine can save time and effort to butt various workpieces, such as metal pipes, wires, bars, profiles, multi-strand wires, spring steel, etc., is inseparable from its longitudinal and transverse pneumatic systems. When the temperature reaches, in order to melt the end faces of the two workpieces and tightly combine them,

The UN6 water-cooled pneumatic butt welding machine uses 3-way water drains to control the water flow. It generally consists of 3 copper valves, 3 see-through tubes, a set of water carriers, 12 copper joints and a filter valve. Its features: ① Compact structure, transparent flow regulator, can be used for liquids with a temperature higher than 90 degrees; ② It has an easy-to-use

The UN6 water-cooled pneumatic butt welding machine is also called a copper-aluminum pipe butt welding machine, a pneumatic metal bar butt welding machine, and a flange butt welding machine. Compared with a semi-automatic butt welding machine, it has an additional pneumatic system and a water system. There are also more things that need to be paid attention to. Xinxing Welding reminds you to read this chapter carefully before operation.

UN6 water-cooled pneumatic butt welding machine needs to be connected to a chiller or a self-made water pump type water tank before use, so that the cold water can circulate to take away heat and extend the life of the welding machine. Then we need to know how to connect the water pipe 1. Connect the cooling water to the "water inlet" joint on the lower right side of the equipment

The UN6 water-cooled pneumatic butt welding machine is a relatively complex resistance butt welding machine. Xinxing Welding reminds you that you must operate in accordance with this safety operating procedure. 1. When starting, turn on the water source, air source, and finally the power supply. 2. After the welding machine is powered on, it should be inspected first

Whether it is a dry-type transformer for a manual butt welder, a water-cooled transformer for a pneumatic butt welder, or an epoxy cast transformer for a high-power welder, Xinxing Welding insists on using all copper to make it, unlike some units that use aluminum instead of copper.

The UN6 water-cooled pneumatic butt welding machine is Xinxing Welding’s 6th generation butt welding machine after 29 years of continuous innovation, research and development, and practical verification. It welds various medium-sized metal bars, wires, pipes, plates, tool steel, spring steel, multi-stranded copper wires, aluminum wires, steel wire ropes, etc. quickly, accurately, well, economically and efficiently.